EasyManuals Logo

TechniSat TECHNISTAR K4 ISIO User Manual

TechniSat TECHNISTAR K4 ISIO
46 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
4
2 Please read this first
Before connecting and using the device, first check that everything has been supplied and familiarize yourself
with the safety instructions.
The following should be included:
1 Digital receiver, 1 Remote control, 1 Quick start operation manual, 1 CD-ROM,
2 Batteries (1.5V micro-cell), 1 HDMI cable, 1 mains cable.
2.1 Safety advice
For your own protection, you should read the safety precautions carefully before using your new receiver.
The manufacturer accepts no liability for damage caused by inappropriate handling, or by non-compliance
with the safety precautions.
Function-related discharge current may occur with electrical equipment. This is acceptable and poses
no risk, even if it is experienced as a slight tingling.
To prevent these discharge currents, mains operated devices (receivers, TVs, etc.) must always be
installed or connected with the power switched off, i.e., devices must be disconnected from the mains
power supply.
- Only operate the receiver in a temperate climate.
- To ensure adequate ventilation, place the receiver on a flat, horizontal surface and do not place any
objects on top of it. There are ventilation slots here to allow heat to be dissipated from the interior
of the unit.
- Do not place any burning objects, such as lit candles, on top of the receiver.
- Do not expose the receiver to water droplets or water spray, and do not place any objects filled with
liquid, such as vases, on top of it. If water gets into the unit, immediately disconnect the mains plug
and inform the service department.
- Do not operate any sources of heat near the unit, which may also heat it up.
- Do not obstruct the ventilation slots.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the TechniSat TECHNISTAR K4 ISIO and is the answer not in the manual?

TechniSat TECHNISTAR K4 ISIO Specifications

General IconGeneral
Product colorBlack
Supported video modes576i, 576p, 720p, 1080i, 1080p
Audio formats supportedAC3
Video formats supportedAVC, MPEG1, MPEG2, MPEG4
HDMIYes
USB version2.0
USB port typeUSB Type-A
USB ports quantity2
USB 2.0 ports quantityUSB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
USB 3.2 Gen 1 (3.1 Gen 1) Type-A ports quantity0
Tuner typeDigital
Demodulation16-QAM, 32-QAM, 64-QAM
Audio decodersDolby Digital
Interactive TV-
Frequency range47 - 862 MHz
Number of tuners4 tuner(s)
Channels quantity4999 channels
On Screen Display (OSD) languagesCZE, DEU, DUT, ENG, ESP, FRE, HUN, ITA, LIT, POL, POR, RUS, SWE, TUR
Signal sourceCable, Ethernet (RJ-45), Satellite
Video resolutions1920 x 1080 pixels
Digital signal format systemDVB-C
Display digits4 digits
Storage temperature (T-T)-20 - 60 °C
Operating temperature (T-T)5 - 35 °C
Operating relative humidity (H-H)10 - 75 %
AC input voltage230 V
AC input frequency50 Hz
Power consumption (standby)3.4 W
Power consumption (typical)8.4 W
ReceptionHD-TV, SD-TV, radio
Symbol rate1.5 - 7.2 Mbaud
Wi-FiNo
Ethernet LAN data rates10, 100 Mbit/s
Package depth212 mm
Package width396 mm
Package height56 mm
Package weight1170 g
Weight and Dimensions IconWeight and Dimensions
Depth135 mm
Width280 mm
Height38 mm
Weight500 g

Related product manuals