8
EN
2.3 Operating breaks
During a storm or lengthy periods of non-use (e.g. holiday), the device should be
disconnected from the mains and the antenna cable removed.
Before you disconnect the receiver from the mains, you should first switch it to
standby mode and wait until the red LED light is displayed.
2.4 Important notes on operation
Operation of the digital receiver is simplified through the use of a so-called "On
Screen Display" (OSD).
This also means that the number of buons on the remote control unit is reduced.
All functions are displayed on screen, and can be controlled by means of a few
control buons.
Functions that are logically related are combined into a "MENU". The selected function
will be highlighted. The red, yellow, blue and green function buons are indicated
by coloured bars at the boom of the screen. These coloured bars represent
dierent functions in the various menus, which can be implemented by pressing
the appropriately coloured buons (multi-function buons) on the remote control.
The function buons are only active when a brief description is displayed in the
appropriate field.
The buon identifications and terms that appear in the OSD menu are shown
inboldtype in this operating manual.
Help: where available, press the blue function buon in the menus to display the
help text; press again to close the help window.
2.5 Important information on data security
Before handing your receiver to your supplier for maintenance purposes, we
recommend that you remove all USB storage media.
The recovery of data is not part of the maintenance and repair work. TechniSat
assumes no warranty for the loss or damage of data during the repair.
2.6 Remote control/Changing the baery
> Open the cover on the baery compartment at the rear of the remote control
by pressing gently on the point indicated and pressing in the direction of the
arrow.
> Insert the supplied baeries, ensuring that the poles are the right way round
(indicator visible in baery compartment).
> Close the baery compartment again.