Technogym element+ Chest Press - Cable Replacement Steps - Part 2; Cable Replacement Safety Warnings

15
Chest Press
A
Replacing the cable of the exercise levers
- insert a thickness of approx. 10 mm (1/2”) under the first weight of the weight
stack;
- bring the two levers into contact with the rubber travel stops;
- tighten the cable and lock down the screws (A) on the other tie rod, always
keeping the levers in contact with the rubber travel stops;
- remove 10 mm thickness (1/2”) from the weight stack.
WARNING
ALWAYS use cables supplied directly by Technogym.
The cables must always be replaced at the first sign of wear, even if it only affects
the outer rubber protection.
WARNING
Every month, carefully inspect the condition of the cables.