Technogym Element+ Lower Back - Weight Stack Cable Tension; Adjusting Cable Tension

16
Lower Back
A
C B
Adjusting the weight stack cable tension
Use the adjuster (C) to adjust the tension of the weight stack cable.
- Remove the rear protective weight stack panel.
- Loosen the locknut (B).
- Tighten or loosen the adjuster (C) to correctly adjust the cable tension.
- Tighten the locknut (B).
- Ret the protective panel on the weight stack.
W
To pull the cable taut after replacement, it may be helpful, when tightening
the screws (A), to insert a thickness of approx. 10 mm (1/2”) under the rst
weight in the weight stack.