33
Run
cont.
Troubleshooting
Problem Cause
Remedy
Problems in
monitoring heart rate
with the chest band
Other transmitters situated nearby.
Move the equipment far enough away to stop signal interference (minimum distance between two
units 80 cm), or use the hand sensor.
Strong interference sources nearby.
Find the interference source (e.g. an electrical domestic appliance) and move it away, or move
the equipment.
Worn heart rate monitor chest band.
Change the chest band.
Chest band transmitter not making proper skin contact.
Dampen the inside of the chest band with water.
Control panel not working properly.
Contact the Technogym Technical Support Service.
Damaged transmitter.
Change the chest band.
Data incorrect or
unreliable with
equipment running
Blocked key on keypad.
If the problem persists, contact the Technogym Technical Support Service.
Equipment next to source of radio interference (e.g. electrical domestic appliances).
Move the equipment to another place or move the domestic appliances.
An internal connector has become accidentally disconnected.
Contact the Technogym Technical Support Service.
Internal contact in control panel.
Contact the Technogym Technical Support Service.
To Next Page
Loading...
