EasyManua.ls Logo

Technogym RUN PERSONAL User Manual

Technogym RUN PERSONAL
38 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
assembly kit
run personal
VisioWeb - Unity2.0 Upgrade
instrUctions
reV. 1.1 - (JanUary 2017)

Other manuals for Technogym RUN PERSONAL

Question and Answer IconNeed help?

Do you have a question about the Technogym RUN PERSONAL and is the answer not in the manual?

Technogym RUN PERSONAL Specifications

General IconGeneral
Incline Range0 - 15%
ConnectivityWi-Fi, Bluetooth
EntertainmentTV, Internet, Games
Max User Weight160 kg (352 lbs)
Heart Rate MonitoringHand sensors
Motor Power4 HP

Summary

General Warnings and Service Advice

Introduction and Manual Scope

Details the purpose of the manual for authorized personnel and explains note meanings.

Technical Assistance Planning Advice

Provides advice for planning technical assistance tasks, including diagnosis and repair.

Service Work General Regulations

Outlines general regulations for service work, including using original parts and tools.

Personal Protective Equipment Requirements

Refers to the Health&Safety After Sales procedure for PPE details.

Run Personal VisioWeb-Unity 2.0 Upgrade Instructions

Disassemble Rear Guard

Step-by-step instructions for disassembling the rear guard of the equipment.

Disassemble Display Unit

Detailed steps for removing the display unit from the equipment.

Disassemble Handlebar and Joystick

Procedure for removing the central handlebar and joystick assembly.

Replace Receiver and Joystick Signal Cable

Guide for replacing the joystick signal cable with a new one.

Assemble Display Sensors and Headphone Board

Instructions for attaching the magnetic sensors and headphone board to the display guard.

Reassemble Unity Display and Guard

Steps to reassemble the Unity display and its associated guard.

Connect Cables to Unity Display

Procedure for connecting various cables to the Unity display unit.

Disassemble and Wire Low Kit

Instructions for disassembling and wiring the low kit component.

Reassemble Display Guard and Low Kit

Steps for reassembling the display guard and the low kit.

Perform Operating Tests

Procedure for performing operational tests on the equipment after assembly.

Configure Equipment Settings

Guidance on configuring the equipment, referencing other manuals.

Manual Version Change Log

Manual Version 1.0 Details

Indicates that version 1.0 was the first release of the document.

Manual Version 1.1 Updates

Lists changes for version 1.1, including picture modifications and notes.

Related product manuals