Technogym RUN PERSONAL - Assemble Display Sensors and Headphone Board

2.5 ASSEMBLING THE DISPLAY MAGNETIC SENSOR AND HEADPHONE
BOARD
1. Fasten the new headphone board 0WQ00507
to the new guard W0008011, with the two new
screws 0Z000145, using a medium Phillips
screwdriver.
A
2. Fasten the two display magnetic sensors
0WR00686 to the guard, using two screws
0ZV00090. Fasten the two screws (A) using a
medium Phillips screwdriver.
RUN HIGH KIT cable 0WCU0931xx.
RUN PERSONAL-UPGRADE VISIOWEB-UNITY 2.0
Assembly instructions- Rev. 1.1
e-mail: support@technogym.com
Page 19