2.10 OPERATING TEST
Perform the following operating tests:
1. Connect the power supply and turn on the equipment.
2. Access the service menu: press next to the home box for a few seconds. Enter 2501. In the DE-
VICE section, check that the equipment's serial number is correct.
3. Test the operation of the speakers, headphones and TV channels.
4. Test the reading of the USB key.
5. Test the reading of the TGS key.
2.11 CONFIGURING THE EQUIPMENT
For details, see the UNITY 1.0 / 2.0 manual User Interface & SW Upgrade available on TG Direct.
RUN PERSONAL-UPGRADE VISIOWEB-UNITY 2.0
Assembly instructions- Rev. 1.1
e-mail: support@technogym.com
Page 33
To Next Page
Loading...
