Need help?Do you have a question about the Technogym Run Excite 700 and is the answer not in the manual?
General| Speed | 0.8 - 20 km/h |
|---|---|
| Incline | 0 - 15% |
| Display Type | LED |
| Heart Rate Monitoring | Hand Sensors, Telemetry |
| Power Supply | 220-240V |
Explains the function of Inverter, Belt Motor, Power Supply, and Download Boards.
Details Elevation + Cut-out Board, Emergency Switch, and Limit Switch functions.
Explains Tread Belt and Elevation Motor drives, including mechanics and controls.
Describes the control logic and signals for the emergency stop function.
Details accessing and using the automatic and manual test menus for 700/900 models.
Explains how to access and use the automatic and manual test menus specific to the 500 model.
Diagnoses and resolves issues related to the tread belt motor encoder not working properly.
Troubleshoots problems where the display or Wellness TV display fails to illuminate.
Addresses issues like no audio sound or no TV picture due to configuration or signal problems.
Troubleshoots problems with the radio function, particularly if the antenna signal is not analog.
Guides on resolving the "EMERGENCY STOP" message on the display.
Provides troubleshooting steps for the "THE EQUIPMENT IS BLOCKED" message.
Covers troubleshooting inverter errors like "IS OFF", "ERROR CODES", "OH", "OC-OLm", "UU", "OU", "EF", "OLr", "Speed Error".
Explains how to remove the inverter and the tread belt motor encoder.
Guides on disassembling the tread belt motor, elevation motor, and tread belt group.
Details procedures for tensioning new and used tread belts correctly.
Explains how to center the tread belt on the running deck.
Explains how to access service menus and outlines the main configuration categories.
Guides through programming the Quixdrive_V inverter using keypad and parameter settings.
Involves checks by qualified technicians on wear, tension, wiring, and lubrication.
To Next Page
