RUN EXCITE: Service & Maintenance Manual - rev. 1.5
9.1.11. EDIT MESSAGES
It is possible to modify the custom messages; press ENTER to invoke a submenu which displays
the first custom message, then use the +/- speed keys to move to the other messages. Press the
ENTER key again to begin editing a message, or hold down the CLEAR key for a few seconds to
turn to the upper menu level. While ed +/- GOAL, select
he desired letter using the +/- speed enter a blank space character. Press
UP-DOWN: xxx
re iting a message, move the cursor using
keys and use CLEAR tot
ENTER to save the modified message, or hold down the CLEAR key to cancel and return to the
upper menu level.
9.1.12. ENABLE UP/DOWN MOTOR
This parameter enables or disables use of the machine incline. To change the selection, when the
ED matrix shows the current setting: L
Press the +/- GOAL keys to select the desired option out of those listed in the table below:
U
P
-D
OWN
ENABLED <default>
DISABLED
Press ENTER to confirm the selection, use the + or – speed keys to move to the next or previous
parameter.
9.1.13. ENABLE MULTI-LANGUAGE MOD E
LANGUAGE : xxx
ress the +/- GOAL number keys to select the desired option out of those listed in the table below:
The machine can be configured to allow selection of the language at each session. To change the
selection, when the LED matrix shows the current setting:
P
L
ANGUAGE
FIXED <default>
OPTIONAL
Press ENTER to confirm the selection, use the + or – speed keys to move to the next or preceding
arameter.
.1.14. RESETTING PARAMETERS TO DEFAULT VALUES
ix shows:
DEFAULT CONFIG.
Press ENTER to confirm the operation, use the + or – speed keys to move to the next or preceding
arameter. If the ENTER key is pressed the LED matrix will show:
p
9
It is possible to reset the user menu parameters to their default values. To select the function, when
the LED matr
p
Page 9.5
To Next Page
Loading...
