Technogym Run Excite 700 - High Kit Version

RUN EXCITE: Service & Maintenance Manual - rev. 1.5
Page 9.24
where X is the address that identifies an inverter parameter as detailed in the tables below:
Drive Parameter Menu address mode
b00-b60 1000-1060 Read-Write
C00-C26 2000-2026 Write only
S00-S58 3000-3058 Read-Write
Press ENTER to change the address a meter, or press + to read the value of
e selected parameter and the followi
press ENTER to read the parameter value, the following message will appear:
VALUE: Y
press ENTER to begin editing the parameter value. When finished, press + and the following
message will appear:
WRITE TO LOW KIT ?
press ENTER to confirm writing the changes to the low kit; at the end of this operation the
following message reappears:
ADDRESS: X
To return to the upper menu level press CLEAR for a few seconds.
9.3.8. HIGH KIT VERSION
This function displays the SW version of the display. To do this, when the LED display shows:
HIGH KIT VERSION
press ENTER, the message that identifies the SW version, will appear.
nd select a different para
ng message will appear: th
READ FROM LOW KIT ?