Technogym Run Excite 700 - LED Test; Serial Ports Test; Test Result

RUN EXCITE: Service & Maintenance Manual - rev. 1.5
Page 6.8
• “Test Successful, press Enter to continue”: This means that the test was completed
press Enter to continue”: This means that the test was not completed
successfully, i.e. that the serial link is inactive and/or the inverter is in an error condition.
he LED test checks the functioning of the display by lighting all the LEDs in the matrix. It also
t ying the frequency to produce different tones of sound.
e sult message, so the user must visually check the outcome.
orts Test
e rts test checks the following communication ports:
t;
Low Kit COM test;
• “Test Successful, press Enter to continue”: This means that the test was completed
rial communications on the selected port are correct.
message will specify COM1 in the case of the CSafe COM test, COM2 in the case
of communications with the low kit, or COM3 in the case of the TGS COM test.
of the various tests:
• COM2;
• COM3;
• KEYBOARD.
Pressing ENTER displays a message with either OK or KO alongside each of the above items,
depending on whether the outcome of the corresponding test was positive or negative.
Note that if this function is invoked without having previously performed any tests, it will show a
negative outcome for all the items. This is because it merely displays the results, but does not
actually carry out the tests.
successfully, i.e. that the serial link is active and the inverter is not in an error condition.
• “Inverter Error,
6.2.1.4. LED Test
T
tes s the buzzer, var
Th test does not produce a re
6.2.1.5. Serial P
Th serial po
• CSafe COM tes
•
• TGS COM test.
Using the + and – speed keys, select the desired test item and confirm by pressing ENTER. The test
can have two outcomes:
successfully, i.e. that se
• “COMx Error, press Enter to continue”: This means that the outcome of the test was
negative: the
NOTE: The communication with the CSafe port and the TGS is not working if any device is not
connected to the port.
.2.1.6. Test Result 6
This function is used for viewing the outcomes
• EEPROM32K;
• EEPROM256K;
• RTC (Real Time Clock);
• OWNZONE;
• COM1;