EasyManua.ls Logo

Technogym Run Excite 700 - Reset Result; Manual Test; Man. Keyboard Test; Man. Inverter Test

Technogym Run Excite 700
226 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
RUN EXCITE: Service & Maintenance Manual - rev. 1.5
Note that if this function is invoked without having previously run any tests, it will show a negative
outcome for all the items. This is because it merely displays the results, but does not actually carry
out the tests.
6.1.1.7. Reset Result
This function clears the output of the Test Results viewing function, resetting the outcomes of all
the tests to KO.
6.1.2. MANUAL TEST
This section groups together tests for manually checking the operation of certain peripheral devices.
After selecting the desired test item using the + and – speed keys, press ENTER to access the tests.
To exit test mode, hold down the CLEAR key for a few seconds.
The various manual tests are described below.
6.1.2.1. Man. Keyboard Test
The manual keyboard test checks the functioning of all the keys on the keyboard. After accessing
the test by pressing ENTER, the message “Press all buttons (beep=OK)” appears on the display.
Pressing each key will produce an audible signal, if a key does not produce the “beep” it means it is
not working properly.
On Wellness TV machines, pressing the keys does not produce an audible signal, but if the key is
working correctly it lights up green.
6.1.2.2. Man. Inverter Test
The manual inverter test displays the values output by the inverter drive during movements of the
tread belt motor. The values displayed are:
Inverter drive frequency (x100);
Speed;
Current (x10);
Voltage.
During the test it is possible to vary the speed using the + and – speed keys, to check that the values
vary accordingly.
6.1.2.3. Man. UpDown Test
The manual UpDown test displays the values output by the elevation motor drive during machine
incline movements. The values displayed are:
Machine incline position;
Number of pulses generated by the elevation motor encoder;
State of limit switch: if it is pressed, “MIN” is shown, nothing in the other condition.
During the test it is possible to vary the incline using the and elevation keys, to check that the
values vary accordingly.
Page 6.5

Table of Contents

Other manuals for Technogym Run Excite 700

Related product manuals