Technogym Run Excite 700 - Distance; Priority Setting; Change Message Language

RUN EXCITE: Service & Maintenance Manual - rev. 1.5
Page 9.2
Press the +/- GOAL keys to select the desired language from the options available. Press ENTER
to confirm the choice, use the + or – speed keys to move to the next or previous parameter.
.1.2. CHANGE MESSAGE LANGUAGE
It is also possible to display the custom standby messages in the language selected with the
receding parameter. To extend the language setting to the predefined custom standby messages,
CHANGE MESS.LANG.
Press ENTER to confirm the select or – speed keys to move to the next or preceding
arameter.
9.1.3. DISTANCE
It is possible to choose between EUROPEAN units (kg and km) or IMPERIAL units (pounds and
miles). To change the selection, when the LED matrix shows the current setting:
DISTANCE : xxx
+/- GOAL keys to select the desired unit of measurement from the options listed in the
table below:
9
p
when the LED display is showing the current selection:
ion, use the +
p
Press the
D ISTANCE
KM <default>
MLS
ress ENTER to confirm the selection, use the + or – speed keys to move to the next or preceding
RIORITY SETTING
If signals are available from both the chest band and hand sensors, this parameter determines which
P
parameter.
9.1.4. P
is the preferential source for displaying the heart rate value. Obviously, if only one of these two
signals is available, it will be used even if not configured as the preferential heart rate source. To
hange the selection, when the LED matrix shows the current setting: c
PRIORITY : xxx
ress the +/- GOAL keys to select the preferential source from those listed in the table below: P
P RIORITY
B AND <default>
HANDS
Press ENTER to confirm the selection, use the + or – speed keys to move to the next or preceding
parameter.