EasyManua.ls Logo

Technogym Run Excite 700 - Menu F

Technogym Run Excite 700
226 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
RUN EXCITE: Service & Maintenance Manual - rev. 1.5
9.7.2.2. Menu F
Par Description Par Description
F-00 Reference frequen F-05 Reference frequency 5 cy 0
F-01 Reference frequency 1 F-06 Reference frequency 6
F-02 Reference frequency 2 F-07 Reference frequency 7
F-03 Reference frequency 3 F-08 Jogging frequency
F-04 Reference frequency 4
9.7.2.3. Menu P
Par Description TG
value
Par Description TG
value
P0 reference setting 3 P63 braking resistor power 1.5
P1 maximum frequency 94.0 P64 braking resistor thermic constan t 10
P2 max. output voltage 230 rial l
enabling
0 P65 inputs setting by se ine
P3 teristic type 2 P66 outputs setting by serial line 0 V/F charac
enabling
P4 torque boost at low revolutions 3 P67 configuration 33 serial line
P5 acceleration time 1 30.00 1 P68 serial line address
P6 deceleration time 1 30.00 P69 answer delay time on serial line 1
P7 “S”-curve characteristic 0.0 base frequency 60.0 P70
P8 modulation frequency 7 30 P71 V/F intermediate frequency
P9 rated current 7.0 P72 voltage 115 motor V/F intermediate
P10 motor thermal constant 30 0.0 P73 ramp start/stop frequency
P11 cosφ 0.78 P74 duction 100 rating of motor output voltage re
P12 motor stator resistance 0.95 P75 50 undervoltage threshold
P13 motor efficiency 84 P76 s blackout 1.0 max. time of short main
P14 min. frequency (offset) for
frequency analog reference
0 200 P77 current limit in accel. for f<f_base
P15 gain for frequency ana
reference
log 1.00 current limit in accel. for f>f_base 200 P78
P16 conversion constant 1.00 current limit at constant speed 200 P79
P17 ssage setting at startup 0 P80 current limit for motor pickup 200 display me
P18 -- 0 0.15 P81 demagnetization min. time
P19 parameters protection code 0 P82 deceleration speed to prevent stall 1.0
at constant speed
P20 l 3 P83 frequency scan time during motor 1.0 programming leve
pickup
P21 2 0.01 P84 voltage reset time 0.2 acceleration time
P22 0.01 0.5 deceleration time 2 P85 tolerance at constant speed
P23 5.00 P86 ramp end delay / constant speed 1.0 acceleration time 3
P24 deceleration time 3 5.00 P87
P25 / acceleration
te
5.00 P88 acceleration time 4
time in jogging sta
P26 deceleration time 4 / deceleration
time in jogging state
5.00 P89
Page 9.35

Table of Contents

Other manuals for Technogym Run Excite 700

Related product manuals