RUN EXCITE: Service & Maintenance Manual - rev. 1.5
Page 9.34
3. Th selected parameter appears on the display (e.g. 1.00).
4. Observe the state of the PRG LED: if it is steadily illuminated it means that the paramete
e
se the ⇑ and ⇓ keys to increase or decrease the va ey progress
c
re le the new e; ra rs on the display (e.g.
-1
e value of the
r can
b modified.
5. U lue (holding down the k ively
in reases the rate of change of the value).
6. P ss E to confirm and enab valu the pa meter code reappea
P 14).
With this pro
stored in perm
cedure, even if the p
(the
ar ill not be
anent memory YE W
re
cr elect c o
bs LED: whe ead m is enable
s r the numb pr
e correctly “done la
pp t he
ameter value has been changed, it w
LLO LED is blinking).
7. P
8. S
ss the M key until menu C appears.
oll using the ⇑ and ⇓ keys to s ode 00 (e.g. C
ily illu
-00), then press E to confirm the ch ice.
d. 9. O erve the state of the PRG
e the ⇑ and ⇓ keys to ente
n st
er 7;
inated, writing to memory
10. U
11. If
ess E to confirm the value.
everything has been don , the ”
value h
message will appear on the disp y for
a roximately two seconds to confirm hat t as been saved.
A to the p me mediately, they ar
a manen em h cific write operation
effected using the command C-00.
lthough the changes made ara ters come into effect im e not
utomatically stored in per t m ory; t is requires a spe
Incorrect programming of the inverter may cause serious damage to the machine, or
r ntially e e, only attem o
program the inverter if you are certain of performing the procedure correctly.
esult in malfunctions pote dang rous to the user. Therefor pt t
WARNING: after reprogramming the inverter, leave parameter d01 (motor frequency)
o
.
The following table shows the default values of the inverter configuration parameters.
.1
n the display.
9.7.2 PARAMETER SETTINGS
9.7.2 . Menu D
WARNING: these are read-only parameters.
Par Description Par Description
d-00 Output frequency d-12 last alarm memory
d-01 Reference f d-13 second to last alarm memory
d-02 Output current(rsm) d-14 third to last alarm memory
d-03 Output frequency(rsm) d memory -15 fourth to last alarm
To Next Page
Loading...
