Technogym Run Excite 700 - Speed Error Message on the Display

RUN EXCITE: Service & Maintenance Manual - rev. 1.5
6.13. “SPEED ERROR” MESSAGE ON THE DISPLAY
is error message if the encoder of the tread belt motor is not working. The machine displays th
This error message will not app
motor encoder.
ear on the 500 model, which does not have a tread belt
This error appears for the first time during opera nd causes the machine to
d by the encoder for
tion of the tread belt, a
completely inhibit all movements, setting parameter PAR 13 to 1. As a result of this, the error
reappears when the machine is turned off and on again, but the machine will be able to function
ormally in open loop mode, i.e. without using the information providen
controlling the inverter speed. Closed loop operation can only be resumed after resetting parameter
PAR 13 to 0.
Is the encoder supply voltage
correct at the input to the
encoder?
Is the encoder supply voltage
correct on patch connector H?
Is the encoder supply voltage
correct at the output of the
elev ation + cutout board?
Replace cable TRM-07
"SPEED ERROR"
MESSAGE ON THE
DISPLAY
YES
NO
YES
NO
YES
Replace cable TRM-
AZION
3
2
1
NO
A
Replace the elevation
+ cutout board
Continued on the following page.
Page 6.45