RUN EXCITE: Service & Maintenance Manual - rev. 1.5
Page 7.18
7.8. DISASSEMBLING THE SENSORS
Only on the 700 / 700E and 900 / 900E.
Figure 7.8-1
1. Turn off the machine and unplug the mains
a using a small Phillips
lead from the wall outlet.
each sensor: For
Back off the 2 screws2.
screwdriver.
Figure 7.8-2
.
screws b using a small Phillips screwdriver.
To re carry out the above
eps in reverse order.
3 Lift up the top sensor.
4. Remove the lower sensor.
. To disconnect the sensors, back off the two 5
assemble the sensors,
st
To Next Page
Loading...
