RUN EXCITE: Service & Maintenance Manual - rev. 1.5
To scroll through the list of available functions, press the + or – speed keys to display the next or
previous item. Confirm the choice by pressing ENTER. To cancel the operation, press the CLEAR
ey for a few seconds.
he tests are divided into two groups: Automatic and Manual. The machine prompts for a choice
achine’s operation in a fully automatic
ENTER to initiate the
ss ENTER again to continue, or press the CLEAR key for a few
econds to return to the higher menu level. The various tests are described below.
6.2
The 2K and 256K memories. The test
s Enter to continue”: Signifies that data packets were successfully
toward the display board.
with the memories.
The to the
from s and
“Incline =15%”: This message appears during the upward movement, when the machine incline
essage appears during the downward movement, when the machine
he test can have two outcomes:
wn), press Enter to continue”: The message indicates that the values do
he specific message (Up or Down) indicates whether the error occurred during
the upward (Up) or downward (Down) movement of the test.
ors.
The d the low kit. The
k
T
immediately upon accessing the troubleshooting menu.
6.2.1. AUTOMATIC TESTS
The tests grouped under this section conduct checks on the m
manner. After selecting the desired test using the + and – speed keys, press
test and then await the result. Pre
s
.1.1. I2C Device Test
I2C Device test checks the communication following the 3
can have two outcomes:
• “Test Successful, pres
transmitted and received
• “EEPROM Error, press Enter to continue”: Signifies that the display board has
communication problems
6.2.1.2. UpDown Test
UpDown test checks whether the number of pulses output by the encoder corresponds
values of the UpDown table stored in the low kit. During the test, the machine incline is moved
0 to 15% and then back to 0. Each incline position is converted into a number of pulse
compared with the value in the UpDown table.
Two messages appear during the test:
-
reaches 15%.
- “Incline =3%”: This m
incline reaches 3%.
T
• “DC Error (Up/Do
not correspond. T
• “Test Successful, press Enter to continue”: This message indicates that the test was
completed without err
6.2.1.3. Inverter Test
inverter test checks the serial communications link between the high kit an
test can have two outcomes:
Page 6.7
To Next Page
Loading...
