Technogym Selection Cable Jungle - Replacing the Cables - General and Side 1; Cable Inspection and Type Requirements; Side 1 Adjustable Outlet Cable Replacement

23
Cable Jungle
E
D
1
A
B
C
Replacing the cables
Cables must always be replaced at the first sign of wear, even if only the outer
rubber protection is worn.
WARNINGS
Carefully check the state of the cables once a month.
ALWAYS use cables supplied directly by Technogym.
When replacing cables, note that the equipment comes with various cable anchor
systems.
Side 1, adjustable outlet cable
The cable is secured with screws (B) and (D), both to the connector and the
anchor points.
- Remove any accessories;
- raise rubber gaiter (A);
- unscrew the screws (B) and pull the cable out from connector (C);
- unscrew the screws (D) and pull the cable out from connector (E);
- remove the whole cable from the equipment;
- insert the new cable (ensuring that it follows the same route as the original
cable, as shown in the illustration);
- insert the cable into connector (E) and tighten screws (D);
- insert rubber gaiter (A) and the connector (C); then tighten the screws (B);
- lower rubber gaiter (A).