Technogym Selection Cable Jungle - Weight Stack Assembly - Sides 2 & 4; Initial Steps for Weight Stacks

11
Cable Jungle
2
4
CB
A
A
Assembly
WARNING
When installing the equipment, use suitable personal protective
equipment.
Assembling the weight stacks on sides 2 and 4
Loosen the two screws (A) inside each of the guards (B) on sides 2 and 4, then
lower the guide rails (C) until they are resting on the floor.
WARNING
Screws (A) secure the guide rails (C); hold on to the guide rails when
loosening these screws to prevent them from dropping on the floor.
The weight stacks must be made up as follows:
- side 2 weight stack with backrest: 9 wide weights, plus wide crosspiece;
- side 4 weight stack with high pulley: 13 wide weights, plus wide crosspiece.