TECHTOP MS1/MS2 Series - After Sales Support; Spare Parts; Rewinding; Bearings

LOW VOLTAGE MOTORS - Installation, operation, maintenance and safety manual - rev. 01 - 1.07.2016
19
6. AFTER SALES SUPPORT
6.1. Spare parts
When ordering spare parts, the motor serial number, full type designation and product code, as stated on the rating plate, must be specied.
For more information, please visit our web site:
www.techtop.com
6.2 Rewinding
Rewinding should always be carried out by qualied repair shops.
Contact TECHTOP before rewinding the motors.
6.3 Bearings
Special care should be taken with the bearings. These must be removed using pullers and tted by heating or using special tools for the purpose.
For more details on how replace the bearings, please contact TECHTOP.
Bearings type mounted on the motor can’t be changed.
WARNING!
Unless expressly authorized by the manufacturer, any repair by the end user will void the warranty and any responsability of the manufacturer on the motor
conformity.
7. ENVIRONMENTAL REQUIREMENTS
7.1 Noise levels
Most of TECHTOP’s motors have a sound pressure level not exceeding 80 dB(A) at 50 Hz.
Values for specic machines can be found in the relevant product catalogues. At 60 Hz sinusoidal supply the values are approximately 4 dB(A) higher
compared to 50 Hz values in product catalogues.