LOW VOLTAGE MOTORS - Installation, operation, maintenance and safety manual - rev. 01 - 1.07.2016
4
1. GENERAL SAFETY WARNING
NOTE
These instructions must be followed to ensure safe and proper installation, operation and maintenance of the machine. They should be brought to the
attention of anyone who installs, operates or maintains the machine or associated equipment. The machine is intended for installation and use by qualied
personnel, familiar with health and safety requirements and national legislation. Ignoring these instructions may invalidate all applicable warranties.
Safety equipment necessary for the prevention of accidents during installation and maintenance during operation must comply with national regulations in
force in the country of installation.
WARNING!
Controls for emergency stop must be equipped with restart lockout devices, after an emergency stop, star command can take effect only after intentionally
reset of the lockout devices.
WARNING!
Electric motors are components with dagerous parts under tension and moving parts during operation.
Improper use, protections removal without having proceeded to dissect the power supply line, disconnect the protective devices, not make periodic
inspections or maintinance, can be cause serious damage.
1.1 Declaration of Conformity
Motor is manufactured in compliance with the international standard IEC 34-1 (EN 60034-1) and to following European Directives:
Low Voltage Directive (LVD) 2014/35/UE
Electromagnetic Compatibility Directive (EMC) 2014/30/UE egarding the intrinsic characteristics to emission and immunity levels.
Directive on the restriction of the use of certain hazardous substances in electrical and electronic equipment (RoHS)
2002/95/EC
The captioned motors are also in compliance with the “Machinery Directive” 98/37/EC( amended by 2006/42/EC), assuming for this, that the motor component
may not be put into service before the machine in which it will assembled, has been declared to be in compliance with the Directive provisions.
When operating the motor, it is necessary to assure that the Standard EN 60204-1 and the installation and safety instructions of the manufacturer’s operating
handbook are observed. Conformity declaration can be supplied when requested.
1.2 Validity
The instructions are valid for the following TECHTOP electrical machine types, in both motor and generator operation.
Series: MS1/MS2 (TM), MSB, MSD, MSC/MYC, MSV (TMV), MYV, T1A,T2A,T3A,TXA
Series: MY/MYT, ML, MC
Series: Y/Y2 ( TM ), YC, T1C ( TM ), T2C ( TM/TCF ), T3C ( TCF ), TCI/TCP, TG,TXC in frame sizes 56-500
To Next Page
Loading...