English - 9 -
If you need any assistance or a customer reference number please contact the TECHWOOD help line on 0845 543 0485
Aerial Connection
Connect the aerial ,cable TV plug to the AERIAL •
INPUT socket located at the rear of the TV.
HDMI 1
SPDIF
Coax.OUT
12V
DC IN
Switching On/Off
To Switch the TV On
Connect the power cord to the 110-240V AC 50/60 •
Hz. Then the standby LED lights up. (The led will
blink during the standby On/Off)
To switch on the TV from standby mode either:•
Press the “•
” button, P+ / P- or a numeric button
on the remote control.
Press the “•
” button, - or + button on the TV. The
TV will then switch on.
• When the mains power is fi rst connected to the device
the light on the front of the unit will start fl ashing
for few seconds, when it stops fl ashing (remains
constant) the TV will be in standby mode.
Note: If you switch on your TV via PROGRAMME
UP/DOWN buttons on the remote control or on the
TV set, the programme that you were watching last
will be reselected.
By either method the TV will switch on.
Note: When the device is coming out of standby the
light on the front of the unit will fl ash until the picture
appears. If you activate the power operation again
(before the light has had time to stop fl ashing) the
device will turn off into stndaby mode again. This is
normal operation and not a fault
Note: The standby light will blink while the TV is
powering up from Standby mode.
To Switch the TV Off
Press the “•
” button on the remote control or
press the “ ” switch on the TV, the TV will switch
to standby mode.
To power down the TV completely, unplug the •
power cord from the mains socket.
Note: When the TV is switched to standby mode,
standby LED can blink to indicate that features such
as Standby Search, Over Air Download or Timer is
active.
First Time Installation
IMPORTANT: Ensure that the aerial is connected
before switching on the TV for the first time
installation.
When the TV is operated for the fi rst time, the •
installation wizard will guide you through the
process. First, language selection screen will be
displayed:
Use “• ” or “ ” buttons to select your language
and press OK button to set the selected language
and continue.
After selecting the language, “• Welcome!” screen will
be displayed, requiring you to set Country, Teletext
Language and Scan Encrypted options.
By pressing “• ” or “ ” button, select the country
you want to set and press “ ” button to highlight
Teletext Language option. Use “ ” or “ ” button
to select desired Teletext Language.
Press “•
” button after setting Teletext Language
option. Scan Encrypted will be then highlighted.
You can set Scan Encrypted as Yes if you want to
scan coded stations.Afterwards select the desired
Teletext Language.
Press • OK button on the remote control to continue
and the following message will be displayed on the
screen:
00_[GB]_(01-TV)_[VESTEL_UK]_MB60_woypbpr_1900UK_IDTV_BRONZE17_16911LED_10071402_50181340.indd 900_[GB]_(01-TV)_[VESTEL_UK]_MB60_woypbpr_1900UK_IDTV_BRONZE17_16911LED_10071402_50181340.indd 9 27.12.2010 17:21:5427.12.2010 17:21:54
To Next Page
Loading...
Need help?
General
