Sirio HH Compact
Instruction and maintenance manual
Instruction n° 207 - Rev. 4 datel 19/10/2017
Copyright © 2017TecmecS.r.l. Translated from the ORIGINAL instructions
6.2 Customized agitation and pause settings
The factory setting (012245) is setted as follow: 20 minutes agitation 240 minutes pause.
If necessary, you can change these settings by doing the following:
- disconnect the machine from the power line
- remove the frame from the bracket
- remove the cover of the panel by unscrewing the 4 rear screws
- following the table below, close the desired contacts with jumpers of the area shown in the figure
To Next Page