Tecmec Sirio HH Compact - 3.6 Symbols Shown on the Equipment; 3.7 Intended Use of the Equipment; 3.8 Non Intended Use

Sirio HH Compact
Instruction and maintenance manual
Page 9 di 24
Instruction n° 207 - Rev. 4 datel 19/10/2017
IT
Copyright © 2017TecmecS.r.l. Translated from the ORIGINAL instructions
3.6 Symbols shown on the equipment
Danger electricall hazard .
Is forbidden to carry out work on the equipment under voltage.
Is forbidden to operate on the electrical system without authorizations.
Danger gear in movements.
Forbidden to load or unload the cans during the agitation cycle.
Mandatory to read carefully the instruction manual, before carry out any operations on
the equipment.
Obligation earthing requirement of the electrical system.
3.7 Intended use of the equipment
The unique feature of this equipment is to store/stow in a sheltered place the color pastes contained in
suitable container/cans (not provided byTecmec) closed by suitable lids (provided by Tecmec).
3.8 Non intended use
Any other use of this equipment that are not described in this manual are considered improper and therefore
prohibited.
In particular it is forbidden:
 Load or unload the cans during the agitation cycle/process, as the drive blades are in motion.
During this process the Led warning is clearly visible on the control panel.
 Any kind of manumission or unauthorized intervention on the electrical control panel.
 Access the motor compartment by unauthorized personnel, and in any case when the plug for the main
power is connected.
 Remove the protection from the motor compartment, if so only during the maintenance phase done only
by expert personnel.
In any case it is absolutely mandatory to remove the plug from the main electrical/power line
before executing any kind of maintenance.