Tecmec Sirio HH Compact - 7 Maintenance; 7.1 Ordinary Maintenance; 7.2 Non Use Periods

To Next Page

To Previous Page

Sirio HH Compact

Instruction and maintenance manual

Page 19 di 24

Instruction n° 207 - Rev. 4 datel 19/10/2017

7 MAINTENANCE

7.1 Ordinary maintenance

To extend the life time of the equipment, the HH Compact needs some flew precaution:

 verify every morning that the power lights in ON;

 verify that all the lids of the cans/tins are properly placed in the agitation zone;

 in case of liquids spill, disconnect the equipment from the main electrical line, clean immediately the

area by using the proper products;

 leave the equipment in always operation mode, even during the evening and weekends , in order to

keep the products always ready to be used;

 verify every six months the correct tightening of the transmission, transmission joints, and the proper

tension of the motor belt;

 verify every months the functionality of the emergency button by following the below steps:

1- press the button during any operation phase, verify that the lights on the control panel are

switched off, and in case of agitation that the motor will stop .

2- once the procedure is done, restore the equipment by pressing the green START button.

For any other kind of issues or doubts, please, contact the Customer Service Dep. in Tecmec.

7.2 Non use periods

In case that the equipment will be switched off, due to a prolonged period of non-use, to avoid a overload

issues on the motor it is necessary to proceed as follow:

 remove all the cans/tins from the shelf's, execute a mixing trough a mixer/shaker or in

alternative a manual mixing, and verify any eventual consistency problem.

 in group of 2-3 locate them on the equipment, and mix them for at least 5 minutes.

 stop the agitation, and add other cans/tints for the mixing cycle. Proceed as above until all the

cans/tins are stored in the equipment.

In case of power failure, verify the reason, once restored the situation, restart the agitation cycle by pressing

the green START button, in order to always ensure a good homogenization of the product.

During the loading and unloading of the cans, stop the agitation cycle by pressing the red STOP button.