Sirio HH Compact
Instruction and maintenance manual
Instruction n° 207 - Rev. 4 datel 19/10/2017
Copyright © 2017TecmecS.r.l. Translated from the ORIGINAL instructions
6.3 Change of function mode
Regardless of the factory settings, if necessary, the electronic control panel can be changed from cyclic
(ON/OFF) into timer (only one stirring cycle).
The change of operation mode from cyclic to timer is possible by acting on the side contact jumper of the
card shown in the figure.
In cyclic operating condition the jumper is not present (open contact) and in timer mode the jumper is
present (closed contact).
When the change is made, follow the previous table for stirring and pause settings.
Close the control panel, supply voltage and check if the operation is the desired one.
To Next Page