EasyManua.ls Logo

Tecnam P-Mentor - Page 263

Tecnam P-Mentor
390 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
P-Mentor - Aircraft Flight Manual Page S01-15
1
st
Edition - Rev. 0
Section 9 - SUPPLEMENTS
S01 AUTOPILOT GARMIN GFC500
LOC/VOR APPROACH
This mode will only be available if the VHF and GPS navigators are
available.
1. NAV Source ..…....……..………………
Tune and activate the desired
VHF frequency
2. HSI Source ..…....……..………………
ENSURE that VHF NAV is the
selected navigation source
selecting CDI to VHF NAV
3. Course pointer …....……..…………..
SET CDI to front LOC course or
desired VOR course
4. NAV Key ………….……………………..
PRESS
5. LOC/ VOR mode ...…………………….
VERIFY armed, capturing and
tracking the course
6. Altitude preselect ...………..…………..
SET to next required step down
altitude
7. Missed approach altitude ...………..….
SET when in ALT mode at the
MDA
At Missed Approach Point:
8. AP DISC button ..…....……..…………
PRESS, continue visually for
normal landing
OR
8. Missed Approach ..…....……..………..
PERFORM
Pressing the GA button will not disconnect the autopilot.
Select NAV or HDG mode to fly the missed approach
procedure.
If the Course Deviation Indicator (CDI) is greater than half
scale deflection, the autopilot will arm the LOC/VOR mode.
The pilot must ensure that the current heading will result in a
capture of the selected course. If the CDI is within half scale
deflection, the autopilot will enter the capture mode when the
NAV key is pressed.

Table of Contents

Related product manuals