EasyManua.ls Logo

Tecnam P-Mentor - Page 264

Tecnam P-Mentor
390 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
P-Mentor - Aircraft Flight Manual Page S01-16
1
st
Edition - Rev. 0
Section 9 - SUPPLEMENTS
S01 AUTOPILOT GARMIN GFC500
GPS APPROACH (LPV, LNAV/VNAV, LP+V or LNAV+V)
This procedure applies only if the GPS navigator is available:
1. Navigation Source ..…....…..………
SELECT CDI to GPS
2. Course pointer …....……..…………..
Verify CDI set to the desired
course
3. APR Key ………….……………………..
PRESS
4. GPS and GP mode ...………………….
VERIFY armed and verify
airplane captures and tracks
course
5. Altitude preselect ...………..…………..
SET Missed approach altitude
after GP capture
6. ALT Key ………….……………………..
PRESS to level off at the MDA
At DA (LPV or LNAV/VNAV) or MDA and Missed approach point (LP+V or
LNAV+V):
7. AP DISC button ..…....……..…………
PRESS, continue visually for
normal landing
OR
7. Missed Approach ..…....……..………..
PERFORM
Pressing the GA button will not disconnect the autopilot.
Select NAV or HDG mode to fly the missed approach
procedure.
If the Course Deviation Indicator (CDI) is greater than half
scale deflection, the autopilot will arm the GPS and GP
modes. The pilot must ensure that the current heading will
result in a capture of the selected course. If the CDI is within
half scale deflection, the autopilot will enter the capture
mode when the APR key is pressed.

Table of Contents

Related product manuals