Tecnam P2008 JC - Flaps Failure; Trim Jamming; Trim Runaway; Trim System Failure

Ed. 1, Rev. 0
Section 3 – Emergency procedures
Page 3 - 21
10.2. TRIM SYSTEM FAILURE
Trim Jamming
Should trim control be inoperative, act as follows:
1. Breaker: CHECK IN
2. LH/RH Trim switch: CHECK for correct position
If jamming persists
1. Trim cutout switch: CHECKON
2. Speed: adjust to control aircraft without excessive stick force
3. Land aircraft as soon as possible.
Trim Runaway
In event of trim runaway, act as follows:
1. Trim cutout switch: OFF
2. Speed: adjust to control aircraft without excessive stick force
3. Land aircraft as soon as possible.
10.3. FLAPS FAILURE
In event of flaps-up landing, account for:
Approach speed: 64 KIAS
Landing length: 35% increased