Tecno Air System RUBY COMPACT - Ignition and Operation Modes Part 1; Display Test Indications; Ignition Procedure

TECNO AIR SYSTEM
Essege Grouppag. 30 di 40
DISPLAY TEST INDICATIONS
DISPLAY
TEST
SIGNIFICATO
OFF Exnguishing phase in progress, lasng about 10 minutes
AC First-stage stove ignion, bioethanol loading and waing for ame ignion
AR second stage ignion stove, ame enrichment.
PA Step followings ignion phases
PH Phase heang stove
P1-P2-P3 Power level set
10...30°C Degree desidered temperature in the stove room
SF Stop Flame: Operaon block for likely bioethanol depleon
CP-TS-PA Control menu available exclusively for CATs
(Technical Support Center)
AF Ignion failure: ignion failure block
H1....H7 Allarm system, the number idenes the alarm causes
Bat1 Finished clock baery (type CR2032)
When the stove is in stand by mode, it visualizes on display OFF
if the stove is in MANUAL or AUTOMATIC mode.
On display it visualizes the text AC (a); overcamed some control cycles and following when the ignion
occours, on the display it visualize the text AR (heang ignion), this phase will last for some minutes it
allowing the correct ignion and heang of the heater exchange.
Aer a few minutes, the heater will go o during the cleaning phase PA, following on heang phase will be
on display PH and following in work phase, indicang the selected power in case of manual operaon,
or indicang the selected temperature in the case of automac operaon.
6. IGNITION/FUNCTIONING/ PROGRAMMING
On stand-by stove press the ON/ OFF buon and start the ignion procedure.
Posion the switch C in posion ON,