Tecno Air System RUBY COMPACT - Ignition and Operation Modes Part 2; Shutdown Procedure; Manual Operation Mode; Automatic Operation Mode

TECNO AIR SYSTEM
Essege Grouppag. 31 di 40
SHUTDOWN
Pressing the ON/OFF buon while the stove is lit it start the shutdown phases which it will provide:
a) Interrupon of fuel load.
b) Exhauson of the fuel present in the burner while keeping the fun working.
c) Cooling the body stove while keeping the fan working (usually x 10’)
d) The “OFF” indicaon on the display with the missing minutes at the end of the shutdown
During the switch o phase, it will not be possible to switch on the stove again, aer switching on the
system, it automacally switches back to standby mode.
MANUAL FUNCTION
In the manual funcon mode it set the power to make the stove work, regardless of the room temperature
in which it is installed.
To select the MANUAL mode press the buon set.
For example to set on the display P2 (power 2)
It is possible to increase the power pressing the buon +
Or for decrease pressing the buon -
AUTOMATIC FUNCTION
In the AUTOMATIC operang mode it can set the wished temperature where the stove it placed.
The stove, automacally, modulates the powers in funcon of dierences between the wished
temperature (on the display) and the temperature detected by the probe; when the desidered
temperature is reached the stove will work at the minimum power taking on power 1 (minimum power).
To select the AUTOMATIC mode press the buon set .
Set on the display example 20°C .
It is possible to increase the wished temperature pressing the buon +
or it decrease pressing the buon -
In AUTOMATIC mode
The display shows alternately, the desidered temperature
and the power automacally selected by the modulang system