Tecno Air System RUBY COMPACT - Advanced Functions Part 1; Remote Activation; Clock and Weekly Timer Setup

TECNO AIR SYSTEM
Essege Grouppag. 32 di 40
REMOTE ACTIVATION FUNCTION (AUX port)
Using a special connecon cable (code LINX000600), you can turn the stove on / o using a remote device
such as: a GSM telephone acvator, a WiFi modem, an environment thermostat, a consensus from a home
automaon system.
For this connecon, contact your authorized service center,
Recommending the use of a device with clean contact with the following logic:
Open contact = stove o
Closed contact = stove switched on
Acvaon and deacvaon takes place with 10 “delay from the transfer of the last command.
In case of connecng the remote acvaon door, you can sll turn the stove on and o from the control
panel; The stove will always be energized respecng the last received order, turning it on or o.
CAUTION, only for mer versions: Acvang the internal mer program (see Weekly Programming Seng)
automacally excludes remote acvaon (aux port), this is to avoid conicts of programmed acvaons.
SELECT CLOCK TIME
Push for 2” the buon SET , we access in order to choose from the menu setup, it will appear on the
display the text TS , pressing the buon we can slide the various menù available, choose the menù
Prog and conrm to enter in programming and pressing again the buon SET
To set the me, with the buon select on the display SET , conrm the selecon pushing the buon
SET , then set the current me:
With the key we increase the me of 15’ each pression, with the buon we decrease the me of 1’each
pression; give conrm the seng with the buon SET, so set the current week day by the buons
( e.g., Monday=Day 1), give conrm the seng with the key SET, to exit from the seng pushing the key
ESC.
WEEKLY PROGRAMMER SETTING
Push for 2” the buon SET , we accede in order to choose the seng menu, it will appear on the display
the text TS , pressing the buons it can slide the various available menu, to choose the menù Prog
and conrm the intenon to enter in programming by pressing the key SET
Pressing the keys we can slide the seng of the me:
Pr OF: enable (On) or disable (OF) completely the using of weekly mer
Pr 1 : Programming band program 1
Pr 2 : Programming band program 2
Pr 3 : Programming band program 3
Set: it allows to set the current me.
To acvate the weekly program, select Pr OF on display , push the buon SET and select On with
the keys to enable select OFF , conrm the seng with the buon SET, to exit from the programming
it push the buon ESC.
How to set the rst me zone of the mer weekly:
Pr 1: This is the n° 1 program, in this me it set a power on me, a turn o me and the days to
witch the Pr 1 applied.
Push for 2” the buon SET , it will access at the seng menù, it will appear on the display the text TS ,
pressing the buons it allows slide the various available menù, choose the menù Prog and conrm
the purpose to enter in the programming pushing again the key SET .
✓
✓
✓
✓
✓
✓