EV 10-50
19
Wireless hybrid arm sy em
Wireless hybrid arm sy em
Management with RFID key
To arm and/or disarm the operating programs via
electronic key, it is necessary to turn on the console
with any key, as long as it is not a numeric key, we
recommend using the YES key, have the key read by
positioning it on the console, press the direct program
command keys P1... P6.
All management procedures are fully described on the
following pages.
Management with Code
For operations that require the entry of an access code,
it is possible to directly enter the code and carry out the
desired management operations.
All management procedures are fully described on the
following pages.
General consultations
To access the consultation functions, you must turn on
the console with any key, as long as it is not a numeric
key, we recommend using the YES key.
Pressing any key lets you access the display of various
status information, you don't need to enter a code to
access this information.
Displays the time and date
Display the message Splash info
Displays all open zones
Each key displays the
open zones of the relevant program
Turn on the console
Turn on the console
Turn on the console
Turn on the console
Have the key read
Select the programs
Turn on the console
22.0°_ System ok
Enter the Code
Choose the procedure
Thu 16-MAY-20
11:02 Work
11:02 System ok
View open zones
Control panel
11:02 System ok
11:02 System ok
- ACCESS -
Key John
View open zones
Program 1
11:02 System ok
ALARM MEMORY
None
T1=22.0°_ RH1=57%
T2=21.0°_ RH2=60%
Displays the temperature and humidity
(in the presence of EV TERMBWL)
Notes
from the installer
If Splash info is not programmed
the stored alarms are displayed
- ACCESS -
Master
Display of the Splash info
To display the splash info message programmed
by the installer, press the MEM key.
Display Splash info + memory
First typing of the MEM key displays the message, the
second typing of the
MEM key displays the
stored alarms.
To Next Page
Loading...
