EV 10-50
21
Wireless hybrid arm sy em
Wireless hybrid arm sy em
3 - MANAGEMENT MODES
Program arming
The procedure allows you to arm one program at a time, to arm more programs repeat the procedure. Arming takes place in two stages
1 Turn on the reader
Press the button
2 Select the program Move the key up to and away from the reading area, one or more times, until the desired program is selected
Program disarming
The procedure allows you to disarm one program at a time, to disarm more programs repeat the procedure. Disarming is carried out in two stages
1 Turn on the reader
Press the button
2 Select the program Move the key up to and away from the reading area, one or more times, until the desired program is selected
The program LED
fl ashes slowly
Program
status
LED
Operations
At the end of the Time-out
the reader turns off
The program LED
fl ashes fast
Program selected Program armedProgram arming
Program LEDs off
Programs disarmed
Press the button
Move the key close, one or more times,
until the desired program is selected
To arm another program repeat
the sequence
The program LED
fl ashes fast
Program
status
LED
Operations
Program disarmedProgram selected
Program LEDs on
Programs armed
Program LED off
Press the button
Move the key close, one or more times,
until the desired program is selected
To disarm another program,
repeat the sequence
3-1.1 - Program selection by key
With the EV PROX BWL key reader it is possible to manage the arming, disarming and partial disarming of the associated
programs (maximum three). System programming defi nes the operating mode of the EV PROX BWL reader: program selection
by key, or, program selection by button.
3-1 - Management by key reader EV PROX BWL
To Next Page
