EV 10-50
37
Wireless hybrid arm sy em
Wireless hybrid arm sy em
3-4.16 - RFID key arming by voluntary Zone exclusion
The procedure allows the user to arm the programs selectively and to select the Zones to exclude from the operating session.The
arming takes place in four phases: recognition of the code, selecting the programs, confi rming arming and selecting the zones to
be excluded.
1 - Key reading
2 - Select the programs
3 - Confi rm arming
It arms excluding the open Zones
Stop arming
3 - Access selective exclusion
Select the Zone
Exclude the Open Zone
3 - Access Zone exclusion
Exit Zone exclusion
Open
zones?
NO YES
1 Key reading Put the key on the reading area, check the fl ashing of the green LED (key read) then move the key away.
2 Select the programs
Press the command buttons P1... P6 or the number keys 1..8 relating to the programs you want to arm or disarm.
If you make a mistake, press the key again, each time the key is changed from OFF to ON and vice versa.
3 Confirm arming
Press the YES key to stop the selection phase and activate the selected programs.
If you do not press the YES key, the selected programs are activated after 15 sec.
4 Zone exclusion
You can exclude open Zones and/or other Zones, which you want to exclude from operating in the current session.
The excluded zones are automatically reactivated in the following operating session.
The possibility of excluding the Zones
is allowed only for keys enabled to
perform the function
11:02 System ok
- ACCESS -
Master
Arming
Program 1
Arming
Control panel ok
OPEN ZONES
Bathroom window
EXCLUDE? by YES
Bedroom Zone
Forced arming
ZONES EXCLUDED
11:02 System ok
To Next Page
