EasyManua.ls Logo

Tecnolec PRO60ESTF - Advice for the Installer

Tecnolec PRO60ESTF
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12
Advice
for the
installer
IMPORTANT
The appliance should be installed by a QUALIFIED INSTALLATION TECHNICIAN.
The appliance must be installed in compliance with regulations in force.
The oven shall be fitted into a standard unit (width and depth 60 cm) but you must ensure
that it is properly ventilated.
CAUTION: Do not lift the oven by the door handle.
WARNING !
We would point out that the adhesive which bonds the plastic laminate to the furniture
must withstand temperatures not less than 150° C to avoid delamination.
The appliance must be housed in heat resistant units.
The walls of the units must be capable of resisting temperatures of 75° C above room
temperature.
NOTE
It is essential that when installing your oven, adequate air circulation is available within
the installation.
Inadequate air circulation may greatly impair the performance of your oven and may
affect adjacent cabinets due to an increase in temperature.
Adjust the hinges of furniture door adjacent to the oven to allow a 5 - 7 mm gap between
the furniture door and the oven frame.