Tecnologic THP 96 User Manual

------Fixed parameter
tAb
ny - nHalf digit display
hdd
ny - nAutotuning
tun
°C°C - °FUnit of measurement
rou
oFon - oFDecimal point
dP
HH - COutput 2 operating mode
HC2
HH - COutput 1 operating mode
HC1
indi - in Sets connection
OCO
Tc: FE
Rtd: Pt
Tc: FE - Cr - rh
Rtd: Pt - Ni
Input probe
PSE
Pion - Pi - nrControl mode
Ft
7 - PROBLEMS, MAINTENANCE AND WARRANTY
ERRORS SIGNALLING: The instrument shows the error message
"EEEE" , when the probe is interrupted or in overrange, or "- - - -"
when the probe (PTC, RTD or normalised signals) is in short-circuit or
underrange; in this case verify the correct probe wiring with the
instrument and afterward proceed to verify itself. In the error condition all
the outputs are disactivated.
HOW TO CLEAN: We recommend to avoid abrasive cleaners or
containing solvents which could damage the instrument.
WARRANTY AND REPAIRS: The instrument is under warranty against
construction vices or defected material, noticed within 12 months from
delivery date.The warranty is limited to the repairs or to the substitution of
the instrument. The eventual opening of the housing, the violation of the
instrument or the wrong use and installation of the product means the
automatically decay of the warranty. In case of defected instrument,
noticed in warranty period or out of warranty, do contact our sales
department to obtain the shipment authorisation. The defected product
must be shipped to TECNOLOGIC with the detailed description of the
failures found and without any fees or charge for Tecnologic, safe
different agreements.
TECNOLOGIC - THP 96 USER MANUAL (I - GB) - Vr. 02 - ISTR 00997 - PAG. 9

Tecnologic THP 96 Specifications

General

Brand	Tecnologic
Model	THP 96
Category	Controller
Language	English