1) To alter parameters:- Press the DSP/FUN key,
until the first parameter 00-00 is displayed.
2) Then use the arrow keys </RESET to select the parameter
required then
Press READ/ENTER key to read the preset value.
3) Use the and </RESET keys to alter the setting of the parameters
as per basic quick start parameter list.
Note:- For full parameter list refer to the instruction manual.
4) To save each parameter change, press READ/ENTER key then
the word END will be displayed.
5) Use </RESET key to select the next parameter to alter and
follow steps 2 to 4 until all changes are complete.
6) Pressing the DSP/FUN key repeatedly will alternate the display
between the preset frequency ( flashing display) and the last parameter
accessed or other selectable displays 0 to 7 when selected by parameter
12-00 according to the table below.
【0】:Disable display 【1】:Output Current 【8】:Count Status
【2】:Output Voltage 【3】:DC voltage
【4】:Temperature 【5】:PID feedback
【6】:AI1 【7】:AI2
To Next Page
Loading...
