TECO E510 - Basic Quick Start Parameter List

Downloaded from https://acdriveshop.co.uk
Page 6 of 9 08/08/14
Basic Quick Start Parameter List
Parameter
Default
Range
Note
00-00
0
0-1
0: V/F control mode
1: Vector mode (SLV)
00-14
10.0
0.1~3600.0
Acceleration time in Secs
00-15
10.0
0.1~3600.0
Deceleration time in Secs
00-04
0
0-2
0: Forward/Stop-Reverse/Stop
1: Run/Stop-Reverse/Forward
2: 3-Wire Control Mode-Run/Stop
00-12
50/60Hz
0.01~650.00
Max frequency limit.
00-13
0.0
0.00~649.00
Min frequency limit
00-02
0
0-3
Start mode:-
0: Keypad
1: Remote
2: Communication
3: PLC
00-05
0
0-7
Main frequency source:-
0: Keypad
1: Potentiometer on keypad
2: External AI1 analogue signal
3: External AI2 analogue signal
4: External up/down frequency control
5: Control by Communication method
6: PID output
7: Pulse input
07-09
0
0-1
Stop method:-
0: Decel to stop
1: Coast to stop
02-01
**A
**A
Motor overload protection according to motor
name plate
13-08
0000
Set to factory setting.
1150: 50HZ system
1160: 60HZ system
1112: Reset PLC
Note:- For Full Parameter List see the Instruction manual