TECO E710-403-H3SF - Page 70

69
LED display Corrective action
• Multi-function input
function set incorrectly.
• Check wiring
EF2 ( flash )
External fault
(S2)
EF3 ( flash )
External fault
(S3)
EF4 ( flash )
External fault
(S4)
EF5 ( flash )
External fault
(S5)
EF6 ( flash )
External fault
(S6)
EF7 ( flash )
External fault
(S7)
EF8 ( flash )
External fault
(S8)
EF9 ( flash )
error of
forward/revers
al rotation
• Check run command
wiring
SE01
Rang setting
error
• Check parameter
setting.
LED display Corrective action
SE02
Digital input
terminal error
• Check multi-function
input setting.
SE03
V/f curve error
• Check V/F parameters
SE05
PID selection
error
• Check10-00 and 10-01
• Check 10-29 and 10-25
• Check 10-29 and 10-03
HPErr
Model
selection error
• Check inverter capacity
setting 13-00.
SE07
PG card error
• Install PG feedback
card.
• Check control mode.
• Set right type for PM
Encoder Type (22-08)
and power on again.
SE08
PM Motor
mode error
• Check control mode.
SE09
PI setting error
• Check pulse input
selection (03-30) and
PID source (10-00 and
10-01).
FB
(flash)
PID feedback
breaking
• Check feedback wiring
• Replace feedback
sensor.
USP
(flash)
Unattended
Start
Protection
• Remove run command
or reset inverter via
multi-function digital
input (03-00 to 03-07 =
17) or use the RESET
key on the keypad to
reset inverter.
• Activate USP input and
re-apply the power.
STP0
Zero Speed
Stop Error
• Adjust frequency
command