TECO F510 User Manual (English)

To Next Page

Page 1 of 11 06/10/17

TECO F510 Inverter

Quick Start Guide

1) Ensure that the Inverter & the motor have the correct KW power and voltage

ratings.

Motor full load amps must not exceed the Inverter rating.

2) Ensure that the supply & Motor cables are connected correctly prior to

power up.

3) Connect supply cable to terminals R/L1, S/L2, T/L3

4) Connect motor cable to terminals U/T1, V/T2, W/T3

(Swap two leads if motor runs in reverse direction).

5) Connect supply Earth and the motor Earth to the drive Earth

terminal.

Note:-

I ) For detailed installation

and wiring refer to the

Instruction

manual.

This guide is to assist you in installing and running the inverter and verify that it is

functioning correctly for it’s main and basic features.

For detailed information and if there are any doubts please refer to the instruction manual.

Step 1

Supply & Motor connection

Need help?

Do you have a question about the TECO F510 and is the answer not in the manual?

TECO F510 Specifications

General

Control Mode	V/F Control, Sensorless Vector Control
Output Voltage	3-phase 0 ~ Input voltage
Cooling Method	Forced Air Cooling
Storage Temperature	-20°C ~ +60°C
Enclosure Rating	IP20
Input Voltage	3-phase 380 ~ 480V
Output Frequency	0~400Hz
Protection Functions	Overcurrent, Overvoltage, Undervoltage
Braking Unit	Built-in
Communication	RS485, Modbus
Rated Power	Varies by model
Overload Capacity	150% for 60 seconds
Operating Temperature	-10 to 50°C
Humidity	95% RH or less (non-condensing)
Altitude	Up to 1000m (derating above 1000m)