TECO F510 - Basic Quick Start Parameter List

Page 7 of 11 06/10/17
（8 keys）
▲
Increments parameter number and preset values.
▼
Decrements parameter number and preset values.
LOC/REM
Alternates frequency and run command source between
LOCAL and REMOTE:
REMOTE mode: inverter is controlled per parameter settings
through control circuit terminals or communication.
LOCAL mode: Inverter is controlled through digital operator.
By default REMOTE mode is effective at power on. Press
LOC/REM key to switch between the modes while inverter is
stopped. LOC/REM key can be disabled by parameter 23-41.
DSP/FUN
Select between Frequency, Function (parameters) and
Monitor displays according to the following sequence.
Frequency screen Function selectionMonitor
parameters Frequency screen.
</RESET
“<” is left shift key. It’s used for changing parameter or value.
RESET key：Use to reset Inverter resettable faults.
READ/ENTER
Used to display the preset value of parameters and for saving
the changed parameter values.
Basic Quick Start Parameter List
Parameter
Default
Range
Note
00-00
0
0, 2, 5
Control Mode:-
0: V/F
2: SLV (Sensorless Vector)
5: PM SLV (Sensorless Vector for
Permanent Magnet Motor)
00-02
0
0-4
Run mode:-
0: Keypad
1: External control terminal
2: Communication
3: PLC
4: RTC
00-05
0
0-7
Frequency source:-
0: Keypad
1: Remote control (Analogue Input AI1)
2: External up/down frequency control
3: Communication
4: Reserved
5: PID output
6: RTC
7: Auxiliary Frequency (AI2)
00-01
0
0-1
Run direction:-
0: Forward
1: Reverse
00-12
100.0%
0.1-109%
Max frequency limit. (default 100%)
00-13
0.0 %
0.0-109%
Min frequency limit. (default 0.0%)