until the first parameter 00-00 is displayed.
2) Then use the arrow keys </RESET to select the parameter
required then press READ/ENTER key to read the preset value.
3) Use and </RESET keys to alter the setting of the parameters
as per basic quick start parameter list.
Note:- For full parameter list refer to the instruction manual.
4) To save each parameter change, press READ/ENTER
END will be displayed.
5) Use </RESET key to select the next parameter to alter and
follow steps 2 to 4 until all changes are complete.
6) Pressing the DSP/FUN key repeatedly will alternate the display between
the preset frequency (flashing display) and the last parameter accessed
or other selectable displays 0 to 7 when selected by parameter 12-00
according to the table below.
【0】:Disable Display 【1】:Output Current
【2】:Output Voltage 【3】:DC Bus Voltage
【4】:Temperature 【5】:PID Feedback
【6】:AI1 Value 【7】:AI2 Value
To Next Page
Loading...
