What to do if TECO JSDEP-20A Servo Drives shows CPU error?
If your TECO Servo Drive displays a CPU Error, it indicates a control system malfunction. Turn off the power and turn it on again after 30 minutes. If the error alarm persists, it may be due to external interference.
Why is my TECO JSDEP-20A Servo Drives disabled?
If your TECO Servo Drive is disabled, it means the input contacts CCWL & CWL are operated at the same time, causing this alarm. To solve this, remove the input contact signal CCWL or CWL. Then, check all input wiring for correct connections. For the selected High/Low logic potential settings refer to Section 5-6-1.
Why do TECO JSDEP-20A Servo Drives overheat?
If your TECO Servo Drive overheats, it means the power transistor temperature exceeds 90°C. Overload for a long duration will cause the driver to overheat. Check and reset the operation system.
What causes absolute encoder battery error in TECO JSDEP-20A Servo Drives?
If your TECO Servo Drive shows an Absolute Encoder Battery error, it means the battery module is removed or the battery voltage is lower than 3.2V. Ensure that the battery module is not removed, the power supply is not losing, and the battery is not short of power and requires replacement.
General| Series | JSDEP |
|---|---|
| Model | 20A |
| Category | Servo Drives |
| Rated Output Current | 20A |
| Control Mode | Position, Speed, Torque |
| Feedback | Incremental encoder |
| Communication Interface | RS-485 |
| Input Voltage | 200-230V AC |
| Protection Features | Overcurrent, Overvoltage |
| Power Supply | Single-phase/Three-phase |
To Next Page
