Page 2 of 7 12/06/13
Apply power to the drive, the display will briefly show the supply voltage
220V followed by flashing.
This is the default ( factory set) frequency.
If the unit has been used previously then it will show the last frequency
programmed.
Step 2
Apply power to the drive
Step 3
Test run from keypad
Press RUN KEY to run.
The frequency will ram up to 5.0 Hz or the user pre-set frequency and
according to the default acceleration ramp time.
Press STOP/RESET key to stop.
The frequency will ramp down to zero according to the default decel ramp
time.
Step 4
To alter frequency from keypad. (Default setting).
Use the Arrow keys and < / Enter
To alter the digits to the required frequency.
eg. 50.0 HZ then use RUN and STOP keys to start/ stop.
To Next Page
Loading...
