TECO L510S Series - Chapter 3 Software Index

12
Chapter 3 Software Index
3.1 Programmable Parameter Groups
Parameter Group No. Description
Group 00 Basic parameters
Group 01 V/F Pattern selections & setup
Group 02 Motor parameters
Group 03 Multi function digital Inputs/Outputs
Group 04 Analog signal inputs/ Analog output
Group 05 Preset Frequency Selections.
Group 06 Auto Run(Auto Sequencer) function
Group 07 Start/Stop command setup
Group 08 Drive and motor Protection
Group 09 Communication function setup
Group 10 PID function setup
Group 11 Performance control functions
Group 12 Digital Display & Monitor functions
Group 13 Inspection & Maintenance function
Group 14 PUMP Application Function
Parameter notes for Parameter Groups
*1
Parameter can be adjusted during running mode Notes: New added in version 05
*2
Cannot be modified in communication mode
*3
Does not change with factory reset
*4
Read only