Changing the Fuse
Changing UV Bulb
Fuse Clip
1
Turn off and unplug the chiller before changing the fuse.
2
Remove the fuse holder from socket using a flathead screwdriver.
3
Remove blown fuse from clip and discard.
Fuse Holder
It is time to replace the UV Lamp
when the AL2 code flashes on the
control panel
4
Push out the spare fuse (contained in the fuse holder), place new fuse in the clip, replace fuse holder.
1
Turn off chiller and unplug the chiller, Remove the housing (see directions on p.19)
2
Unscrew the ring nut for the UV sterilizer port.
Changing the Fuse
Spare Fuse
Note: Some wires were removed for these photos
To Next Page
Loading...
