3
Remove rubber stopper from the quartz sleeve
4
Unplug the old UV lamp from the 4-pin socket., remove and discard lamp.
5
Slide new UV lamp into quartz sleeve, plug into 4-pin socket, return rubber stopper into
sleeve
Do not touch the glass of the UV bulb with your bare hands.
6
Tighten ring nut over quartz sleeve
7
Replace housing and air filter. Replace ring nuts and valves.
8
Open shut off valves, restart pump and check for leaks. Turn UV on by pressing UV button.
9
Hold down UV button for 10 seconds to reset AL2 code.
1
Turn off chiller and unplug the chiller, Remove the housing
(see directions on previous page)
2
Remove the blue plastic cover from fuse, remove old fuse from clips
WARNING:
Do not touch the glass of the UV bulb with your bare hands.
Oils on your hands will dramatically decrease the lifespan of the UV lamp. Use a clean
3
Install new fuse, replace blue plastic cover, replace chiller housing.
cloth
t
o
handle
the
lamp
during
installation.
To Next Page
Loading...
